2point - perspektive?

[Jorgensen]

i wonder if it's possible to do two-point perspektive (where vertical lines are all vertical) using the octane camera? (i only know this from sketchup).

i guess i can set the z-height of both camera and target to the same, but is that the way to do it?

thanks
jorgensen

[mojave]

Hi,

There's been a discussion about this already:

viewtopic.php?f=9&t=10178

I hope it helps.

[Jorgensen]

ok - so the solution it to set the z-height to the same for both camera and target, and then adjust via the lens shift parameter?

i just wonder what the camera option "persp. correction" is used for then?

thanks
jorgensen

[mojave]

Yes, that should do the trick as well, but make sure your camera's up vector is pointing upwards.