Color picker position not saving

[formatio]

Hi

I found that color picker is in default position somewhere on the left top (more or less).
When I move it so it is closer to my materials panel, close it by clicking "ok" (chose color or not, doesn't matter), next time I open it it's not in the previous place (that I moved it to) but in new position, and even different position than default.

Would be nice if the position of color picker could be saved (during the session) .

Also couple of times rhino and the plugin crashed - always when I was meddling with color picker (I am not sure, but it might be when I slide sliders too fast - I'll investigate it further to give better feedback on this)

Regards,
Mac

[face_off]

Hi Mac

Would be nice if the position of color picker could be saved (during the session) .

Done in the next release (saves the position to the config.xml file, so persists between session.

Also couple of times rhino and the plugin crashed - always when I was meddling with color picker (I am not sure, but it might be when I slide sliders too fast - I'll investigate it further to give better feedback on this)

I've had 2 or 3 crash reports from that Color Chooser dialog fro McNeel. I posted fixes for these in 2.5.2.11. Are you using that version? If you get any crash - pls send me the crash report.

Paul

[formatio]

Hi Paul,

Yes, it appears that I am using 2.5.2.11, only octane plugin installed.

I'll catch crash dump next time Rhino crashes and post here. (Crash happened only two times so far )


Regards,
Mac