Significant LV vs PV differences
Moderators: ChrisHekman, aoktar
No color pipeline, all default settings, just boring old 8bit srgb renders.
I've narrowed it down, the image brightness changes as the render resolution changes (!?) My guess is that the glow post effect isn't scaling properly somehow. This is naturally screwing me over as all my tests are at 1k res and my final output is 8k. So it isnt a live view vs final render difference, its a resolution difference. To reproduce, just render the project at 1k then 8k.
I've narrowed it down, the image brightness changes as the render resolution changes (!?) My guess is that the glow post effect isn't scaling properly somehow. This is naturally screwing me over as all my tests are at 1k res and my final output is 8k. So it isnt a live view vs final render difference, its a resolution difference. To reproduce, just render the project at 1k then 8k.
Good to know. Very bad issue here.
Architectural Visualizations http://www.archviz-4d.studio
Yes, this is an old an well known limitation of Post Effect.
It is not smart enough to take into consideration the resolution scaling.
The only workaround that I know is to save the mid/low res Post Effect as separated AOV, then gradually over scale it to the final resolution
ciao,
Beppe
It is not smart enough to take into consideration the resolution scaling.
The only workaround that I know is to save the mid/low res Post Effect as separated AOV, then gradually over scale it to the final resolution
ciao,
Beppe
Do you know any other software than AE or Fusion that create good looking such effects ?elsksa wrote:Or, consider doing the bloom/glare in post, unless the intention was to output a "SOOC" file from Octane, ready for viewing.
Architectural Visualizations http://www.archviz-4d.studio
What about preview post effects in Octane Live Viewer using lock resolution mode at 100% ? It should render them using final resolution set in render settings.
Architectural Visualizations http://www.archviz-4d.studio
Thats what we'll probably do from here. Get it close normally, then do a final full res, but scaled down LV check to get it back where it was. Its just annoying that well need to then toggle this back and forth during subsequent changes.SSmolak wrote:What about preview post effects in Octane Live Viewer using lock resolution mode at 100% ? It should render them using final resolution set in render settings.