Need Help With Octane

[sublime]

Hi,

The problem that I have is, sometimes when I export to Octane from 3DMax I end up with modelling problems within Octane. As you can see from the image below, my windows have been filled back in aswell as the windows themselves going a little wierd.



http://imageshack.us/photo/my-images/805/barn.png/

The only way I can find a way to fix this is to go back into Max and model again, in the exact same way as before and sometimes it then works.... Is this something that I need to be doing in the exporting stage on modelling stage?

Hope you can help?

[Jaberwocky]

Check if your normals are pointing the right way.That's the only thing i can think of at the moment.

[sublime]

Yeh Ive checked the normals but still the same problem.....Its only the odd few windows and walls that it happens on..the rest are fine and they are copies

[Jaberwocky]

Not sure what else to suggest.

have you tried remapping UV's on the parts that are causing problems ?

[sublime]

Yeh I tried Uv mappin....I think it is something to do with the Editable Poly that is attached to it, Iv managed to fix it now, took a while, but all working..Thanks for response

[Jaberwocky]

No Probs.