I installed the addon AP OCTANE 2.0 - but, when I try to use it, the message appears: "There was an error when running this operation! It has been printed to the console."
I'm using the Blender 3.4 version.
What may be the problem?
Can someone help me?
problem with addon AP OCTANE 2.0 for Blender
Forum rules
For new users: this forum is moderated. Your first post will appear only after it has been reviewed by a moderator, so it will not show up immediately.
This is necessary to avoid this forum being flooded by spam.
For new users: this forum is moderated. Your first post will appear only after it has been reviewed by a moderator, so it will not show up immediately.
This is necessary to avoid this forum being flooded by spam.