Hi, I have two .orbx files that contains each one a scene and I want to combine them in Octane standalone. Is this possible? Does someone know how to do it?
Thanks in advance.
Combining two scenes in Octane Standalone
Forum rules
For new users: this forum is moderated. Your first post will appear only after it has been reviewed by a moderator, so it will not show up immediately.
This is necessary to avoid this forum being flooded by spam.
For new users: this forum is moderated. Your first post will appear only after it has been reviewed by a moderator, so it will not show up immediately.
This is necessary to avoid this forum being flooded by spam.
Hello,
Yes it is. I do it very often, although not via ORBX but with the .ocs (standalone project files), it should be the same (I did try with ORBX a few times).
I will demo it and post a GIF (open it in the web browser if it does not auto-play - it is not a static image screenshot!).
I go fast, because it is a GIF, but it basically comes down to
- CTRL C (or X to cut) and V to paste the elements from one scene to the other
- Combining them with Geometry Group Nodes
I could show you some more complex scenarios. In fact, I demonstrate some of that on my website:
https://www.elsksa.me/scientia/cgi-offl ... standalone
Do not hesitate if you have any questions.
Yes it is. I do it very often, although not via ORBX but with the .ocs (standalone project files), it should be the same (I did try with ORBX a few times).
I will demo it and post a GIF (open it in the web browser if it does not auto-play - it is not a static image screenshot!).
- CTRL C (or X to cut) and V to paste the elements from one scene to the other
- Combining them with Geometry Group Nodes
I could show you some more complex scenarios. In fact, I demonstrate some of that on my website:
https://www.elsksa.me/scientia/cgi-offl ... standalone
Do not hesitate if you have any questions.