Hi,
Whilst using Vectron I have the following issue.
If i initiate Vectron all is good.
See the video link below for further info however i will also describe the issue.
https://vimeo.com/597080638
pass=vec
The problem:
If i use the sliders to change the parameters even the slightest movement will make the value jump from its original state (say a value of 10) to the hundreds of thousands. This means i cannot control the parameters via the sliders.
So if i have a power of 8 and i try to move it only a millimetre to move to a power value of 10, it jumps to a huge number.
Any assistance appreciated.
Thanks
Chris
Vectron slider value problem
Moderators: ChrisHekman, aoktar
