Hello, can someone please help me make gradients work?
For some strange reason, the colours are mixing instead of showing a smooth transition between them.
I'm using OctaneX, full version (for some reason, I can ONLY post in this forum, so apologies if it's not the correct one).
I've tried using:
- Octane gradient
- C4D gradient
- Using a Sinewave node between the gradient and the diffuse
None of these work. I must be doing something wrong, but I can't figure out what. So if you can help me that would be greatly appreciated.
Thanks in advance!
Problem with gradients in C4D
Forum rules
For new users: this forum is moderated. Your first post will appear only after it has been reviewed by a moderator, so it will not show up immediately.
This is necessary to avoid this forum being flooded by spam.
For new users: this forum is moderated. Your first post will appear only after it has been reviewed by a moderator, so it will not show up immediately.
This is necessary to avoid this forum being flooded by spam.
two modes are available for C4D gradient+noises: OSL mode or auto baking conversion. OSL is not yet supported in PR2. It should be the reason. PR3 is available for trying with OSL
Octane For Cinema 4D developer / 3d generalist
3930k / 16gb / 780ti + 1070/1080 / psu 1600w / numerous hw
3930k / 16gb / 780ti + 1070/1080 / psu 1600w / numerous hw
-
bradiohead
- Posts: 3
- Joined: Thu Aug 13, 2020 11:49 am
By OSL are you referring to the one selected in the screenshot?
If that's the case, my mac freezes the moment I assign it to the 'Diffuse' channel. I have to reboot it completely.
Any other ideas or possible workarounds? I just need a simple, two colours linear gradient.
Thanks!
If that's the case, my mac freezes the moment I assign it to the 'Diffuse' channel. I have to reboot it completely.
Any other ideas or possible workarounds? I just need a simple, two colours linear gradient.
Thanks!
- Attachments
-