LV refresh and Performance Timer - how to set ?

[GIOLETS]

As subject: I need to refresh my memory...
How to use these parameters in order to speed up heavy scene management?

Luca

[GIOLETS]

I'm sorry but I renew my question since I haven't found nothing in Octane documentation and sometimes I've noticed an Octane warning like: "see Other Lv times" or similar (it's a very short warning).

Luca

[GIOLETS]

I renew again my question but I work usually with very heavy project, so I need to speed up the Live viewer updates, material editing, and so on.

I remember in the past that Ahmet suggest us how to set :
- LV refresh time
- Performance Time

I have ready-to send a typical scene , very heavy, that takes almost 6 minutes to start in Live Viewer also if few elements are switched on.
Very high time of reaction of each material editing.
I am sure it's because I've a very bad Octane Settings setup so I want to improve it.

I am ready to send the scene if Ahmet or Beppe want to help me (and other users).

Thanks a lot again!

Luca

[aoktar]

Performance timer:
It's a threshold value for enabling/disabling the scene checking. When scene iteration/checking time is higher than this value, plugin will temporarily disable the check process until mouse hold released. Imagine like that indrag with mouse will be disabled.