Hello,
I am demoing Octane for Blender and just trying the different things out.
I read that it was now possible to use smoke with Blender for Octane. While I can get the Volumen Medium to work I can nok get it to work with the smoke simulations. I used the same methods you would normally use with Cycles, but with Octane nodes instead.
I could not find any documentation about this. Is it possible?
/OutOfTime007
Blender + Octane + Smoke
Forum rules
For new users: this forum is moderated. Your first post will appear only after it has been reviewed by a moderator, so it will not show up immediately.
This is necessary to avoid this forum being flooded by spam.
For new users: this forum is moderated. Your first post will appear only after it has been reviewed by a moderator, so it will not show up immediately.
This is necessary to avoid this forum being flooded by spam.
Hi OutOfTime007,
Take a look at this short video tutorial I've made about new features, including smoke simulation, of OctaneRender for Blender v.3. The video had been made before fire simulation support was added, so that part is not shown and explaned there.
And new Hair system features are shown here:
Take a look at this short video tutorial I've made about new features, including smoke simulation, of OctaneRender for Blender v.3. The video had been made before fire simulation support was added, so that part is not shown and explaned there.
And new Hair system features are shown here:
Win 8.1 x64, i7-4930K 64GB, 2 x GTX-690
-
Synthercat
- Posts: 284
- Joined: Mon Aug 30, 2010 11:12 am
- Location: Thessaloniki Greece
Nice work! +1
Linux Mint 19.3 | GTX-1080Ti | AMD FX-8320 (OCed 4.4GHz) | 16GB RAM