Bendbox wrote:Great job, love the series!
Is your exterior eggshell texture map custom made?
Rikk The Gaijin wrote:These are fantastic, how did you model the albumen? Especially the white filament in it?
enricocerica wrote:Thanks to everyone, just made 2 prints in about 65x45cm and the result is great thank to a resolution of 5120x3200 I
Again I made several tests and finally for the albumen I went for SSS material which was the best deal, for the filament I really didn't know where to go. I tried SSS but it wasn't good, I finally used a flat plane with a smoke image with alpha channel and surprisingly the result was acceptable.
Users browsing this forum: No registered users and 12 guests