Failed to Instal Octane

A public forum for discussing and asking questions about the demo version of Octane Render.
Forum rules
For new users: this forum is moderated. Your first post will appear only after it has been reviewed by a moderator, so it will not show up immediately.
This is necessary to avoid this forum being flooded by spam.
Post Reply
User avatar (Default)
Cyril_G
Posts: 4
Joined: Wed Feb 17, 2016 6:29 pm

Hi,

I want to instal and try Octane Renderer but I can't load it after installation.

Message is on screenshoot.
Image

In english :
"The procedure entry point is not found in the dynamic link library..."


I cheak for Hardware requierement but i have a Quadro 2000 vidéo card with CUDA enable.

Have you solution for me ?
Thank a lot,

Cyril
Top
User avatar (Default)
abreukers
OctaneRender Team
Posts: 500
Joined: Thu Aug 18, 2011 12:28 am

Hi, that's most likely because the Nvidida graphics driver is not updated. You can try downloading a recent driver from here. cheers...
i72630QM @ 2.00GHz | 6GB RAM | 2GB GeForce GT 540M | Win7 64bit
Top
User avatar (Default)
Cyril_G
Posts: 4
Joined: Wed Feb 17, 2016 6:29 pm

Yes was right. I have update my drivers and Octane lauched.

Thank !

Best regards
Top
Post Reply

Return to “Demo Version Questions & Discussion”