Hello!
If i edit a material in inventor, is there a way to push just the material change to the octane viewport or do i have to close and re open the viewport? It takes 10 minutes at a triangulation tolerance of 1 to port the scene to the viewport. would be nice if i could push the materials without having to report everything.
Thanks!!
Frifer
Update material in inventor
Forum rules
For new users: this forum is moderated. Your first post will appear only after it has been reviewed by a moderator, so it will not show up immediately.
This is necessary to avoid this forum being flooded by spam.
For new users: this forum is moderated. Your first post will appear only after it has been reviewed by a moderator, so it will not show up immediately.
This is necessary to avoid this forum being flooded by spam.