I have a large project of 1,500 images made difficult because I cannot simulate orthographic views (straight on) using Octane Cameras.
While I realize it's not "realistic" per se, it would be very handy for some technical illustrations.
Same applies to Camera Correction.
I realize that it exists for the Free Camera but the Free Camera lacks some of the other controls.
Camera Correction / Orthographic Target Perspective
-
lunarstudio
- Posts: 71
- Joined: Fri May 16, 2014 12:36 pm
- Location: Boston, MA
- Contact:
Hi Lunar.
To vertically correct a camera use an octane camera, and make sure its is horizontal and then use x and y offsets in the camera object panel. I think this is actually a more correct way than the method max uses.
For the orthographic camera, use a standard camera, set the Orthographic projection tickbox, and off you go.
To vertically correct a camera use an octane camera, and make sure its is horizontal and then use x and y offsets in the camera object panel. I think this is actually a more correct way than the method max uses.
For the orthographic camera, use a standard camera, set the Orthographic projection tickbox, and off you go.