Hi Guys,
As pictures, I always found I cannot zoom any closer when the scale of view turn red. Any reason behind that.
Don't you guys think octane need some 2d navigation interface to help?
Also not sure about some of the new parameter in 2.2.
scale of view
Moderator: face_off
- Scottiefeng
- Posts: 183
- Joined: Fri Aug 01, 2014 1:46 pm
That is not AC plugin issue, or is it?
You might better post this in the general forum to get response on that,
and to keep the AC threads about AC
Cheers,
You might better post this in the general forum to get response on that,
and to keep the AC threads about AC

Cheers,
4090+3089ti & Quad 1080ti
ArchiCAD25, ofcourse Octane & OR-ArchiCAD plugin (love it)
http://www.tapperworks.com
http://www.facebook.com/pages/TAPPERWOR ... 9851341126
http://www.youtube.com/user/Tapperworks/videos
Agree with Jeroen.
Quickly....you need to move the camera back - because you are getting to the limits of the FOV. Moving the camera back might run into the wall, so you might need to remove the wall.
Paul
Quickly....you need to move the camera back - because you are getting to the limits of the FOV. Moving the camera back might run into the wall, so you might need to remove the wall.
Paul
Win7/Win10/Mavericks/Mint 17 - GTX550Ti/GT640M
Octane Plugin Support : Poser, ArchiCAD, Revit, Inventor, AutoCAD, Rhino, Modo, Nuke
Pls read before submitting a support question
Octane Plugin Support : Poser, ArchiCAD, Revit, Inventor, AutoCAD, Rhino, Modo, Nuke
Pls read before submitting a support question