Hi everyone, I´m new at this. I just rendered my first video and it has some problems. However I don´t know where to begin. Is this a problem with the textures or the kernel settings? The still render does not look so bad, but when it moves it is all messed up. What part of the manual should I look into? Any help very welcome, thanks.
https://www.dropbox.com/sh/pqcbg26ax4u6 ... B6l5a?dl=0
Vic.
Lot of help
Forum rules
Important notice: All artwork submitted on our public gallery forums gallery forums may or may not be used by OTOY for publication on our website gallery.
If you do not want us to publish your art, please mention it in your post clearly. (put a very red small diagonal cross in the left right corner of the image)
Any images already published on the gallery will be removed if the original author asks us to do so.
We recommend placing your credits on the images so you benefit from the exposure too, and use a minimum image width of 1200 pixels, and use pathtracing or PMC. Thanks for your attention, The OctaneRender Team.
For new users: this forum is moderated. Your first post will appear only after it has been reviewed by a moderator, so it will not show up immediately.
This is necessary to avoid this forum being flooded by spam.
Important notice: All artwork submitted on our public gallery forums gallery forums may or may not be used by OTOY for publication on our website gallery.
If you do not want us to publish your art, please mention it in your post clearly. (put a very red small diagonal cross in the left right corner of the image)
Any images already published on the gallery will be removed if the original author asks us to do so.
We recommend placing your credits on the images so you benefit from the exposure too, and use a minimum image width of 1200 pixels, and use pathtracing or PMC. Thanks for your attention, The OctaneRender Team.
For new users: this forum is moderated. Your first post will appear only after it has been reviewed by a moderator, so it will not show up immediately.
This is necessary to avoid this forum being flooded by spam.
-
mark0spasic
- Posts: 146
- Joined: Thu Mar 08, 2012 4:46 pm
Just change Rayepsilon value from 0 to 0.1
AMD FX 6300, 24 GB RAM, Gigabyte ga-990fxa-ud5, 2x MSI GTX 780 3GB
-
aguilarpierri
- Posts: 23
- Joined: Thu Sep 18, 2014 11:49 pm
Thank you, that worked just fine. Thanks for the help.
-
aguilarpierri
- Posts: 23
- Joined: Thu Sep 18, 2014 11:49 pm
Hi Mark just one thing. My alpha image transparency does not work anymore. Can this be fixed? Is there another way to make a transparency that does not disappear? It wasn´t working very well to begin with, so any way to change it would be an improvement. It was a diffuse material with an alpha image in the opacity tab. Thanks.
-
aguilarpierri
- Posts: 23
- Joined: Thu Sep 18, 2014 11:49 pm
https://www.dropbox.com/sh/pqcbg26ax4u6 ... B6l5a?dl=0
Hi, Rayepsilon got rid of the circles but not of this horizontal lines. Any idea what is cousing that? is the sample count too low?
Thanks
Vic
Hi, Rayepsilon got rid of the circles but not of this horizontal lines. Any idea what is cousing that? is the sample count too low?
Thanks
Vic
-
aguilarpierri
- Posts: 23
- Joined: Thu Sep 18, 2014 11:49 pm
Ok, I just ran a couple of tests with a another simpler project and it turns out those horizontal lines are created when I save it to a quicktime movie. I saved it to a JPG sequence and all is well. What is the best format to use when saving a final render?
Thanks Vic.
Thanks Vic.