any docs for network rendering ?

[HHbomb]

Thanks Karba for the update !!!!
Just looking around for new features. What is the procedure to make network rendering ?
In network rendering, I can't see other computers even with deamond installed.

[Karba]

Thanks Karba for the update !!!!
Just looking around for new features. What is the procedure to make network rendering ?
In network rendering, I can't see other computers even with deamond installed.

Have you read this?
http://render.otoy.com/manuals/Standalo ... ge_id=1248

[HHbomb]

In fact Deamon wasn't launched
But now in the list, octane show "0 GPUs"
In Deamon slave window : "CUDA driver is too low - can't use cuda" Need to update driver card ? to which version ?

[abstrax]

In fact Deamon wasn't launched
But now in the list, octane show "0 GPUs"
In Deamon slave window : "CUDA driver is too low - can't use cuda" Need to update driver card ? to which version ?

Just install one of the latest NVIDIA graphics drivers. Since 1.54 we require support for CUDA 6 on Windows and on Linux (because of the added Maxwell support). The latest WHQL drivers provide CUDA 6 support.

[HHbomb]

thanks abstrax and Karba to be here !!!!

[Martians]

My master window says name and status unknown - and the daemon window is stating that the master address is 0.0.0.0:0

I'm running latest Nvidia drivers and have disabled firewalls - any ideas what could be causing this?

Martin

[HHbomb]

hello...
same here, unknown and 0Gpus...

[buggy]

I just purchased the 2.0 upgrade (standalone + Max plugin) and installed it. I have two machines that I haven't networked but are connected to the same switch for internet access, and I suppose can be set up with Home networking. However, I just read something that made me wonder if I have to purchase a second license of Octane in order to run the slave. Is that the case?

[abstrax]

My master window says name and status unknown - and the daemon window is stating that the master address is 0.0.0.0:0

I'm running latest Nvidia drivers and have disabled firewalls - any ideas what could be causing this?

Martin

Could you please close eand restart the daemon and then post a screenshot? Thanks.

[[email protected]]

I also got Invalid slave, than later on unknown
here's a screenshoot

http://prntscr.com/3repsh