Octane can't render from LW10. Any clue?

[Battery555]

Hope anybody could shed some lights here. When I click on the render button from Octane Lightwave exporter. The warning bar below the LW 10 indicated (Unknown command. "Generic_OctaneRxportOBJ") And it does nothing from there. I'm MAC user. Below is my config:

2X2.4Ghz Quard-Core Intel Xeon
6Gb RAM
Nvidia Quadro 4000
Lion 10.7.4
All objects set to non sub patch.
exporter version= 0.3 and 0.4

What am I missing here? Thanks heaps!

[vipvip]

change the exporter version: the 0.3 is to my mind the best ( i would rather say the less buggy !.. )

[Battery555]

Thanks vipvip! I tried that as well and no luck. The octane exporter show up but the when click on the render button it does nothing other than the cursor turned into the spinning "beach ball". After awhile the spinning stop and it resume normal again. But there's no rendering taking place! My LW10 is 64bit but Octane render is only 32bit. Is that the caused of it?

[vipvip]

it should be perhaps.
But anyway, the lightwave exporter is very buggy, whatever the version...