ch0pper wrote:Man problem is that you're impatient. You're trying to do something that took me two months to learn. in 2 days
The problem sounds like its groupings within Zbrush. Or again, it could be subdivision level that you not exporting right.
You would have learned this in the basics of zbrush.
Keep in mind that you cannot subdivide the mesh in Zbrush or you will not be able to import your obj, since you've changed the vertice information.
Don't mess with the poly count or anything like that in Zbrush. It'll make a mess for sure.
Your best bet if you do want to do fibre mesh hair and you want to do it you don't want to take the time to learn and sit down and read Zbrush. Without the hassle of learning
go buy this product . It would do exactly the same Z brush, but very much easier for you to understand and export easly. with no hassle
http://www.furrythings.com/LAMH.Manual.1.0.pdf
http://www.furrythings.com/introduction/
Yhanx Chopper. I am a bit impatient, he he he... I found a tutorial that rebelmommy from Rendo made withing 10 steps. she used poser 4 or something with Zbrush 2, so some of the things look a bit different, but I recon Ill figure it out.
Thanx again for the whole Idea.
