OTOY Forums

Posted: **Thu Jun 21, 2018 2:39 pm**

Greetings everyone.

I am using a noise node to drive the bump map of an Octane material.

In the bump channel, there doesn't seem to be a value for the amount of the bump effect.

What is the most common way to control this?

Thank you.

Joe.

Posted: **Thu Jun 21, 2018 3:05 pm**

Hi,
you can use a color correction node between the noise, and the Bump pin, and play with Power, Gamma, Contrast, to get the effect you want.
ciao Beppe

Posted: **Mon Jun 25, 2018 2:26 pm**

multiply with a float texture

OTOY Forums

Easiest way to increase or lower a bump map?

Easiest way to increase or lower a bump map?

Re: Easiest way to increase or lower a bump map?

Re: Easiest way to increase or lower a bump map?