Page 1 of 1
Once again scatter object question
Posted: Fri Jun 02, 2017 11:57 am
by Harzer
Hi there, here comes a other description of my problem. 1. I placed a cube under a scatter object and use a plane to scatter onto. 2. Now I used a gradient with some turbulence in the scale channel of the scatter object. 3. What happens is not what I wished to get. 4. In this picture you can see the gradient and how it is placed in the channel. Why is it turned 45 degrees and world y axis and 90 degrees un x axis and why is it repeated two times.
Best regards
Max
Re: Once again scatter object question
Posted: Fri Jun 02, 2017 2:36 pm
by bepeg4d
Hi Harzer,
please, try with the attached scene:
ciao beppe
Re: Once again scatter object question
Posted: Sat Jun 03, 2017 11:19 am
by Harzer
Hi Beppe, thanks a lot. But after I open your scene I got the same result that I had with my scene. Are there special preferences in octane that I might have to change?
Thanks
Max
Re: Once again scatter object question
Posted: Sat Jun 03, 2017 11:28 am
by aoktar
Harzer wrote:Hi Beppe, thanks a lot. But after I open your scene I got the same result that I had with my scene. Are there special preferences in octane that I might have to change?
Thanks
Max
Could you please try with 3.06.2?
Re: Once again scatter object question
Posted: Sat Jun 03, 2017 11:40 am
by Harzer
Sorry, I also had this idea in this moment and tried it. Now it works! Sometimes it is very easy to solve the problems.
Best wishes from Bavaria
Max