What is the best way to create an assembly input for a normal map? I have not had much luck with this. The normal map is noodled into multiple materials within the assembly. Thanks.
Re: Assembly input type for normal map
Posted: Wed Apr 13, 2016 6:31 am
by face_off
Not sure I fully understand your question, but does the video below answer your question?
Re: Assembly input type for normal map
Posted: Wed Apr 13, 2016 3:38 pm
by adamnerva
Thanks for the video Paul. I have managed to get this far. I guess 2 main questions remain. Do I always use a float input for everything? And how do I create a filename node? I've seen your are doing this, but I have not figured it out. Is that created simply by dragging an image from the clips viewer into the graph? Thanks!
Edit. OK, so yeah, dragging an image from the clips browser creates the filename node. Cool. So all that remains is the question about whether I should use float for all assembly inputs. Thanks.
Re: Assembly input type for normal map
Posted: Thu Apr 14, 2016 2:54 am
by face_off
So all that remains is the question about whether I should use float for all assembly inputs.
Yes, all Octane node connections in the Schematic are "float" types.
Paul
Re: Assembly input type for normal map
Posted: Thu Apr 14, 2016 3:34 am
by adamnerva
face_off wrote:
So all that remains is the question about whether I should use float for all assembly inputs.
Yes, all Octane node connections in the Schematic are "float" types.
Paul
Got it. Thanks a lot, Paul. You have been very helpful. I appreciate it.