Page 1 of 1
Transparent mesh when mesh not closed
Posted: Fri Mar 25, 2016 4:15 pm
by cristiangiro
Hello
i'm having this problem
whenever i have an open mesh, for instance when i keep the invisible part with no polys; i see through it, like it was a bit transparent
i can see the background or the lights through it
any solution for this? i searched the forum but no luck
thanks in advance!
Re: Transparent mesh when mesh not closed
Posted: Mon Mar 28, 2016 12:10 am
by face_off
Can you post some screenshots showing the problem pls?
Re: Transparent mesh when mesh not closed
Posted: Tue Mar 29, 2016 12:28 pm
by cristiangiro
hi,
as you can see i can see the hole through the mesh even if the material is not transparent
any suggestion? i'm sure is some dumb mistake I've made
thanks!
Re: Transparent mesh when mesh not closed
Posted: Tue Mar 29, 2016 9:55 pm
by face_off
Can you send me the .lxo pls?
Paul
Re: Transparent mesh when mesh not closed
Posted: Wed Mar 30, 2016 10:53 am
by cristiangiro
done!
Re: Transparent mesh when mesh not closed
Posted: Wed Mar 30, 2016 11:51 am
by face_off
Thanks for sending through the file. The Opacity of the First Material in the Material Mix is 0.968, so it is very slightly transparent. Set the Opacity to 1 and the mesh is no longer partially transparent.
Paul
Re: Transparent mesh when mesh not closed
Posted: Wed Mar 30, 2016 12:59 pm
by cristiangiro
sorry, that was awkward, but in my defense i was sure it was my fault
)))
thanks!