Particle flow toolbox 3 rendering unwanted geometry!
Posted: Mon Oct 22, 2012 7:53 am
Hi there,
This is my first post so please be patient if I’m doing something wrong!
Yesterday I bought Octane and must say, it’s amazing and very powerful rendering engine!
However I found a problem with rendering:
I’m trying to render a scene with glued particles covered by a cloth mesh (particle skinner) using toolbox 3 from orbaz, the problem is that even with hidden particles (I usually set display particles = none) it still renders my particles (geometry) in Octane while it shouldn’t!
Does anybody know how do I get rid of them in rendering screen in order to see only the particle skinner on them?
My spec
i7 920 – 2,69 Ghz, ASUS MATRIX GTX 580, 12 GB RAM Kingston 1333 Mhz
THANX
This is my first post so please be patient if I’m doing something wrong!
Yesterday I bought Octane and must say, it’s amazing and very powerful rendering engine!
However I found a problem with rendering:
I’m trying to render a scene with glued particles covered by a cloth mesh (particle skinner) using toolbox 3 from orbaz, the problem is that even with hidden particles (I usually set display particles = none) it still renders my particles (geometry) in Octane while it shouldn’t!
Does anybody know how do I get rid of them in rendering screen in order to see only the particle skinner on them?
My spec
i7 920 – 2,69 Ghz, ASUS MATRIX GTX 580, 12 GB RAM Kingston 1333 Mhz
THANX