OTOY Forums

Hello,
I have a small problem with the emitter ...
As you can see from the picture, the light is projected above and not below.
Is there a way to reverse the direction?

Thank you!

yes

turn the plane mesh that's being used for the emitter through 180deg.it looks like the normals are pointing upwards.Therefore the emitter is emitting the light in the direction of the normals.

Hope that helps

Jaba

turn the mesh or flip the mesh normals

Jaberwocky wrote:yes

turn the plane mesh that's being used for the emitter through 180deg.it looks like the normals are pointing upwards.Therefore the emitter is emitting the light in the direction of the normals.

Hope that helps

Jaba

Thank you.
I will try.

Bye

Refracty wrote:turn the mesh or flip the mesh normals

Thank you.
This is also very interesting.
You can do this inside of Octane?

Ciao

No you can't. I hope you will be able to do it in a future release.

Thank you.
I hope so too.
I solved by working in the modeler.
Bye