Page 1 of 1
Texture mapping
Posted: Thu Jan 26, 2012 10:03 am
by m_m_
Hallo.
Thanks to those who will give me a help.
How to map the texture so that it appears one side of a Sir Biss?
Yes: 1 Sir Biss
No: 10, 20, 30 etc. Sir Biss
I can not.
Thanks
P.S.
Only Octane Standalone
Re: Texture mapping
Posted: Thu Jan 26, 2012 10:06 am
by matej
Tweak the scale parameter on the texture node and / or properly map your plane to the image before you export
Re: Texture mapping
Posted: Thu Jan 26, 2012 10:10 am
by m_m_
matej wrote:Tweak the scale parameter on the texture node and / or properly map your plane to the image before you export
Thank you.
There is no command to place an image on a surface only once?
Grazie.
Non esiste un comando per posizionare una immagine solo una volta su una superficie?
Re: Texture mapping
Posted: Thu Jan 26, 2012 10:53 am
by matej
If you are referring to tiling of the texture, than you must take care of this yourself - as said, properly map the plane on the texture in your 3D application and / or adjust the scale of the texture in Octane.
Re: Texture mapping
Posted: Thu Jan 26, 2012 10:59 am
by m_m_
matej wrote:If you are referring to tiling of the texture, than you must take care of this yourself - as said, properly map the plane on the texture in your 3D application and / or adjust the scale of the texture in Octane.
O.K.
Grazie