Re: Scatter node help
Posted: Thu Feb 05, 2015 12:23 am
Thank you again, I'll give it a try...Rhino again? yes...aparently the importer is real dodgy and it is a shame that such software have to deal with such simple task although even 3DMAX has sometime problem in exporting..ill check normals and reportPhantom107 wrote:1. Make sure the surface you are importing into Phantom Scatter is NOT double-sided. Phantom Scatter will work with the geometry you give it, so don't give it geometry that you don't want to scatter on. I take it this a Rhino OBJ exporting problem again?
2. My software will never put stuff ouside of the surface of the OBJ you imported. Make sure that the OBJ you are scattering around in Octane (the piece of grass) is placed at the center of the world (0, 0, 0). (as stated in the manual figure 06.1)