Page 2 of 2
Re: Render Slave
Posted: Wed Sep 09, 2020 2:35 pm
by samsue
stays like this for more than 10 minutes
Re: Render Slave
Posted: Thu Sep 10, 2020 7:41 am
by samsue
- 3dsmax_s2GRUKjId8.png (4.56 KiB) Viewed 1992 times
what do these values mean?
my scene has only 600mb its nots possible that takes more than 10 minutes to start rendering
I was reading these two topics too
viewtopic.php?f=81&t=66727&hilit=Net+Updating&start=10
viewtopic.php?f=80&t=66644&p=336371&hil ... ng#p336371
-----------------------------------
seems to be the same problem, very slow network.
But I wanted to understand why exactly.
paride can you explain?
Re: Render Slave
Posted: Thu Sep 10, 2020 8:57 am
by jimho
what about to export the scene to standalone, and get it network rendered?
Re: Render Slave
Posted: Sun Sep 13, 2020 5:05 am
by coilbook
have you tried a new cat cable from master to slave?
Look for my old posts I had similar problems.
This is one of them
viewtopic.php?f=81&t=66727
I think switching to windows 10 solved it. It's been a long time ago. Try turning off webroot off if you have it.
Re: Render Slave
Posted: Sun Sep 13, 2020 5:08 am
by coilbook
It looks like you found my old posts.
This was a solution to one of the update errors i had
"Hi Paride,
thanks. Yes you are right. That was the reason for all the problems. I found out one of the slaves had a bad cat7 when you wiggle it connection would drop (Reason for constant slave failed errors) And seems that the router sometimes would turn some ports amber where you have to plug and unplug Ethernet cable. I also got rid of the switch from three slaves and just ran three lines to the router. it is better now. Thanks"
Re: Render Slave
Posted: Thu Oct 15, 2020 8:52 am
by samsue
coilbook wrote:It looks like you found my old posts.
This was a solution to one of the update errors i had
"Hi Paride,
thanks. Yes you are right. That was the reason for all the problems. I found out one of the slaves had a bad cat7 when you wiggle it connection would drop (Reason for constant slave failed errors) And seems that the router sometimes would turn some ports amber where you have to plug and unplug Ethernet cable. I also got rid of the switch from three slaves and just ran three lines to the router. it is better now. Thanks"
I happened to see that on one of my video cards on the render server the fan was not working ( each card has 2 ) sio i removed this card from the server.
During the day I noticed that the server was starting to render much faster and the cuda erros are gone and on top of that, I installed a 10gb network card on my workstation.
I assume that because of overheating something has broken on the video card, despite the temperature according to MSI afterburn, was always the same as the others.