Some comments on proxies....
Sometimes the obj file when imported in octane is not centered or out of view. In this cases you can recenter the object axis in 3d max and re-export. Then you can import the new obj as proxy in Octane.
The size adjustment of proxies is by using scaling and not exact dimensions. On the contrary in archicad mode, we have the snap function and also the objects can have certain dimensions. So each object can be placed exactly next to each other through point snapping,
but that is not the case in the viewport of Octane.
I still haven't figure out which point of an archicad object is considered as center for octane to place the proxy. For any object position configuration in octane this has to be done visually and not graphically.
If we have a table in archicad for example 2x1 what is the best method to import a proxy exactly at this dimensions and at the exact same perimetric position? Do we need to adjust all the imported objects in 3d max first before importing or there is some other way?
Thank you