How are you setting the Inventor element to "Invisible" pls?- The plugin loads all elements of the assembly, regardless of whether they are visible or not in Inventor. And all this elements are shown on OctaneRender viewport.
I think this would be very difficult to implement. I suggest rotating the IBL image, or rotating the actual Inventor element being rendered.- For convenience, it would be nice to make the automatic orientation of lightening depending on the orientation of the ground plane or view cube in Inventor.
The triangular tolerance impacts the number of polygons generated by Inventor for curved surfaces. So it is possible there is just one element in the scene creating all the polygons with your tolerance amount of 0.1. Would it be possible to send me the scene with didn't finish loading pls? Then I can take a closer look at the root cause of the problem.- I've tried to open few assemblies with more than 100 elements and didn't reach the end of the load scene elements even when I reduced triangular tolerance to 0.1.
Unfortunately this is very difficult - because there is no way to determine which geometry has changed in Inventor, and therefore which Octane scene elements to replace. How long is the scene taking to load?- If reopen plugin in same scene, it reloads all assembly again. If you can make some "caching" of geometry that has not being changed during last opening of render, it will save a lot of time to users.
Paul