face_off wrote:I will try to fix this when doing the 2.11.1 build later this week.
Thank you for fast reply!
There are some additional moments:
- The plugin loads all elements of the assembly, regardless of whether they are visible or not in Inventor. And all this elements are shown on OctaneRender viewport.
- For convenience, it would be nice to make the automatic orientation of lightening depending on the orientation of the ground plane or view cube in Inventor.
- I've tried to open few assemblies with more than 100 elements and didn't reach the end of the load scene elements even when I reduced triangular tolerance to 0.1.
- If reopen plugin in same scene, it reloads all assembly again. If you can make some "caching" of geometry that has not being changed during last opening of render, it will save a lot of time to users.
The main advantage of Octane for Inventor is very fast rendering. And all these nuances, especially the long import process, reduce this advantage to a zero.
I hope you take it into account in future updates.
Best regards,
Viacheslav.
Win 8.1 64bit, GTX780 Ti, i7-3660x, 32Gig RAM, 344.75, Inventor 2015, plugin v.2.16