PROBLEM WITH FX-LINKER MATERIAL DUPLICATION

Forums: PROBLEM WITH FX-LINKER MATERIAL DUPLICATION
Newtek Lightwave 3D (exporter developed by holocube, Integrated Plugin developed by juanjgon)

PROBLEM WITH FX-LINKER MATERIAL DUPLICATION

Postby vipvip » Sat Aug 06, 2011 6:24 am

vipvip Sat Aug 06, 2011 6:24 am
I was very happy because the particles instancer of lightwave was workink with Octane.But there is a big problem:

when duplicating the instance geometry ( see attahced pict) with the particle FX linker, and after expoting the scene to Octane, Each cube has A NEW MATERIAL in octane ( ex: 500 cube -> 500 materials ): so that is quite impossible to change the material of cube, specially when working with animation...

Holocube, could you resolve this problem please ? ( and the "escape" fonction too -> look at previous post )
Thank you per advance !!!

( Lightwave 10.1 + Exporter v0.3 ( same problem with 0.4 ) )

IT'S PERHAPS AN OCTANE PROBLEM because when i load the exported octane-OBJ in lightwave, it doesn't shows the 500 cubes-mats but only ONE (this is logic... -> see the top attached pict).
Attachments
cubesmats_lw.JPG
cubesmats.JPG
vipvip
Licensed Customer
Licensed Customer
 
Posts: 726
Joined: Fri Apr 22, 2011 9:28 am

Return to Lightwave 3D


Who is online

Users browsing this forum: No registered users and 2 guests

Mon Oct 14, 2019 11:57 pm [ UTC ]