Haven't had time to test the new exporter until now. But its a great release! No more annoying switchbacks for the measurements/project filepaths etc. Everything just goes wroom!
One question about the measurements.. Are you 100% sure that your exporter scale isnt 10-times smaller than it actually is? I always model in scale, and if I do a unit export in decimeters (as I always understood that 1-unit in Softimage corresponds to 10cm for some obscure reason) well, then I end up with polynormals looking odd. When I set it to meters the result looks correct. Do I make any sense? When doing a decimeter export the model in Octane seems like each unit is 1cm instead of 1 dm. I don't know, havent done a scientific test for this, just felt odd when working on my current project and using the last soft2octane exporter..
Btw, can I write .exr in the file exporter now, or will it save down the image as .png anyway?
/Regards Peter K