Thank you for your support !
I understand "Lock Resolution button", today ...

Today, I meet strange trouble about file size.
Currently I Update to Poser 11.3.816 with Octane Render V4.05, and I meet storage trouble on Octane Render film size control.
I set file size that 2048*2732, but I press "Open Viewport", it render with 927*1137.
May be this rendering size is fixed ...

SO, Sorry, I have not test yet
I have little bit confuse about 2019.1, because License Control changed it.

Additionally you can reach Poser 11.2 down load site from following.
https://www.posersoftware.com/downloads
This site is operate by PoserSoftware Inc, owned by Bondware Inc.

> I don't understand what you mean by this.
My test as latest Poser by Smith Micro, Thet Version is Poser 11.xx

This Information about Poser 11.2, shipped by Renderosy / Bondware, that release at Sept. 19.
Currently, All of Poser need change to Poser 11.2 from Renderosity / Bondware, all of license ...

Good news, Rendeosity Poser 11.2 has solved this trouble. No trouble with Poser UniMesh 1 or Higher.

PS
bad News, Poser 11.2 has another new BUG, for example, If you miss apply Mat Pose for figure, Poser 11.2 will marge wrong Material for OBJ, it will be make glower size with no mean

Thank you for your support.
I found that this problem is cause by Figure->Skinning Method->Poser Unimesh as 1 or higher.
I set this value as 0, it can render, show attached picture.
Currently, Renderosity Poser Development team is not ready, may be. Therefore I can accept close this topic now. But ...

I meet seriously trouble on Victoria4 with Sasah-16 2019 edition.
Octane cannot render eye, show my sample, Poser FireFly and SuperFly has no trouble, but Octane Render can't render eye.
At rendering time, I try to check by Material Picker on Octane rendering screen, Octane Material tab locate at ...

In my case, caused by Multi GPU card on one board with specific sense.
Currently, I choose only one GPU on board, almost sense has no problem.

Yes, it is.