OTOY Forums

Hi, team
I would like to have in Octane for C4D, the same blue bar indicating usage of P2P memory pool of Nvlink when 2x3090 are connected.
Helps indicate resource use for users.
Regards,

Pointed this to Dino as well, to think of adding this.

NVLINK (on consumer cards) might look like a dying thing (we do not have physical connector on 40 or 50 line cards), however, I have hear that NVIDIA is will support P2P over PCIe (not sure how true that is so far, but I guess OTOY devs in contact with NVIDIA might have a bit more information if or when that would come). So all in all, even if I do not use C4D plugin, could only add that this is still relevant and useful thing to have.

glimpse wrote:Pointed this to Dino as well, to think of adding this.

NVLINK (on consumer cards) might look like a dying thing (we do not have physical connector on 40 or 50 line cards), however, I have hear that NVIDIA is will support P2P over PCIe (not sure how true that is so far, but I guess OTOY devs in contact with NVIDIA might have a bit more information if or when that would come). So all in all, even if I do not use C4D plugin, could only add that this is still relevant and useful thing to have.

Thank you, Glimpse.
I am not going after 40xx or 50xx until power deliver is sorted out properly.
I really like the 2x3090 configuration and would like to have best oversight of its resources usage.
I take some scenes to the edge of memory usage and I like to know how Octane is handling it in C4D.
Regards,