Page 1 of 1
octane license is not active
Posted: Wed Feb 23, 2022 3:32 am
by coilbook
I get this error during rendering. I use 2020.2.5 11.14 Especially when using phoenix or large scenes Thanks
Re: octane license is not active
Posted: Wed Feb 23, 2022 4:31 am
by coilbook
and this message once slaves disconnect.
This has nothing to do with license but slaves just quit rendering after 10-20 frames one has no error the other one this error attached.
Sometimes it will save session stopped. And then launches another one right bellow.
Then when I go to the network pref both slaves are running but in viewport preview none showing up. I have to check and uncheck for them to come back. Something is blocking them I guess. Do you know what?
Re: octane license is not active
Posted: Wed Feb 23, 2022 11:34 am
by paride4331
Hi coilbook,
did you solve your issue?
There may have been intermittent issues with licensing requests few hour ago.
Regards
Paride
Re: octane license is not active
Posted: Wed Feb 23, 2022 2:28 pm
by coilbook
paride4331 wrote:Hi coilbook,
did you solve your issue?
There may have been intermittent issues with licensing requests few hour ago.
Regards
Paride
Hi Paride,
With license yes. But one of the slaves still disconnects after 20 frames with this error "disconnecting daemon ........ since it didn't reply for more than 20s
"
Re: octane license is not active
Posted: Wed Feb 23, 2022 2:43 pm
by coilbook
paride4331 wrote:Hi coilbook,
did you solve your issue?
There may have been intermittent issues with licensing requests few hour ago.
Regards
Paride
Here is the screenshot of one of the slaves that stops. I am not sure why. Firewalls are off. And on the master side it says slave is running but if I open octane viewport it is not. I have to uncheck and recheck the box.
If you look at the screenshot it says stop logging and then it restarts slave right away. This happens during actual rendering.