Page 1 of 1
H&F: Raising amount of fur
Posted: Mon Jan 18, 2021 7:42 pm
by mbetke
I try to raise the amount of fur for this fluffy guy. But it doest work. No matter what I change, the amount doesn't raise so the fur gets more dense.
Re: H&F: Raising amount of fur
Posted: Tue Jan 19, 2021 3:08 pm
by paride4331
mbetke wrote:I try to raise the amount of fur for this fluffy guy. But it doest work. No matter what I change, the amount doesn't raise so the fur gets more dense.
Unbenannt-1.jpg
Hi mbetke,
hair and fur support seems to work.
Does Octane work well by decreasing fur in your scene?
Is the amount of fur correct using the scanline render?
Regards
Paride
Re: H&F: Raising amount of fur
Posted: Tue Jan 19, 2021 3:19 pm
by mbetke
It was a ready setup from a bought 3d model. So it works for a lot of people using VRay.
I can reduce the amount of fur but not raise it over a certain amount. All other settings seem to work.
Re: H&F: Raising amount of fur
Posted: Tue Jan 19, 2021 5:17 pm
by paride4331
Hi mbetke,
The total number of hairs generated is max 10000000.
When Octane stops to increase them?
Regards
Paride
Re: H&F: Raising amount of fur
Posted: Wed Jan 20, 2021 10:10 am
by mbetke
It seems to stop at 1.000.000 when I change from 1Mio to 5Mio nothing happens.
Re: H&F: Raising amount of fur
Posted: Tue Jan 26, 2021 12:24 pm
by paride4331
Hi mbetke,
the developers are investigating about this issue.
Regards
Paride