Page 1 of 1
PhoenixFD Problems
Posted: Wed Jan 29, 2020 6:53 pm
by wxyz
Trying to render the smoke example. Too much diffusion in the Max viewport and a black frame in the Octane viewport. Is there a guide for setting the Octane-volume? The original file rendered without showing any smoke even though the main viewport showed the smoke.
Re: PhoenixFD Problems
Posted: Thu Jan 30, 2020 8:45 am
by paride4331
Re: PhoenixFD Problems
Posted: Thu Jan 30, 2020 7:15 pm
by wxyz
Thanks..I get the warning "selected channel not found in simulation data" in the OctaneVolume, even though the preview shows the smoke. Are the samples for use with PhoenxFD 4 and Octane 4.05?
Re: PhoenixFD Problems
Posted: Fri Jan 31, 2020 7:36 am
by paride4331
Re: PhoenixFD Problems
Posted: Mon Feb 03, 2020 8:07 pm
by wxyz
Scene renders black...selected channel not found in simulation.
Does this work with Octane 4.05 and PhoenixFD 4.0?
Re: PhoenixFD Problems
Posted: Tue Feb 04, 2020 10:02 am
by paride4331
wxyz wrote:Scene renders black...selected channel not found in simulation.
Does this work with Octane 4.05 and PhoenixFD 4.0?
Hi wxyz,
Yes, it does.
you would run the sim pressing "start simulation".
Regards
Paride
Re: PhoenixFD Problems
Posted: Tue Feb 04, 2020 3:27 pm
by wxyz
Ran the sim and it shows in the viewport, but when I add the volume it cannot see the data.
Re: PhoenixFD Problems
Posted: Tue Feb 04, 2020 3:41 pm
by wxyz
Re: PhoenixFD Problems
Posted: Tue Feb 04, 2020 3:43 pm
by paride4331
Hi wxyz,
Volume medium is just connected to Octane volume and particle WSM in my sample scene.
you would only to start the sim.
Regards
Paride
Re: PhoenixFD Problems
Posted: Thu Feb 06, 2020 5:58 pm
by wxyz
OOps...I was using PhoenixFD 3.0