Page 1 of 1
Need Help:Wireframe material
Posted: Sat Jun 29, 2019 3:54 pm
by jimho
is it possible in octane to have a material similar to the attached image ,the building block in the center of the image is rendered from a material type named "Vray wireframe" or something similar to it.
I wander can we do the similar in octane?
Many thanks
Re: Need Help:Wireframe material
Posted: Tue Jul 02, 2019 11:45 pm
by frankmci
There's one in the LiveDB/Misc called, "line art," that can get you started. It's a bit more complicated than you probably need, but should give you some ideas if you take some time to dissect it. Personally, I use a combination of a Dirt (with Invert Normal checked) and a Falloff node, each individually choked with a Comparison node, then multiplied together. It's not perfect, but with a little tweaking in post, it does the job.
Re: Need Help:Wireframe material
Posted: Thu Jul 04, 2019 6:19 pm
by jimho
frankmci wrote:There's one in the LiveDB/Misc called, "line art," that can get you started. It's a bit more complicated than you probably need, but should give you some ideas if you take some time to dissect it. Personally, I use a combination of a Dirt (with Invert Normal checked) and a Falloff node, each individually choked with a Comparison node, then multiplied together. It's not perfect, but with a little tweaking in post, it does the job.
It works pretty well,
Thanks a lot