Page 1 of 1
Lw 2019 render saves to two places
Posted: Sun May 12, 2019 4:53 pm
by mikefrisk
I render properties (LW) I have unchecked everything in buffers and output, and in octane render passes I have selected a location and some beauty passes. When I render it renders to the location selected within octane as well as lightwaves "Base Save Path". I dont want it to render to lightwaves path at all. What am i doing wrong?
Re: Lw 2019 render saves to two places
Posted: Sun May 12, 2019 9:06 pm
by Rainbow-3D
Happened in LW2018, and now in 2019. I never could stop LW to save the frames, so I created a Trash folder, I put this path in the lw saver (the right path for the frames is in the octane render passes) and I know to delete all what I find in this trash folder. But it is a stupid no-solution.
Re: Lw 2019 render saves to two places
Posted: Mon May 13, 2019 2:27 pm
by mikefrisk
Rainbow-3D wrote: I created a Trash folder
That's basically what I had to do as well. I'll submit a bug report to newtek.
Re: Lw 2019 render saves to two places
Posted: Mon May 13, 2019 3:31 pm
by juanjgon
Hi,
We are investigating this issue with the help of the LW dev. team. I hope to know more soon ...
Thanks,
-Juanjo
Re: Lw 2019 render saves to two places
Posted: Mon Jun 17, 2019 7:42 pm
by 3dreamstudios
If I understand your issue, you may just put the same render path in both places. That's what we do. It is still a pain, no doubt...to have to set both up properly, but we don't see duplicates saves (that I'm aware of) My HD would be full by now If it was saving somewhere else too
Maybe that will help temporarily.