Octane Sketchup Exporter - 1024-03
Posted: Fri May 13, 2011 3:26 pm
Here's version 1024-03
Please install it following the instructions in the README file or Help.pdf...
It addresses an issue raised by 'Area D'.
It's been updated to allow a project-folder to be located somewhere other than on the the base Windows drive [which is usually 'C:'] - i.e. it's somewhere else, on 'mapped-drive' e.g. 'X:' - and to make the OBJ/MTL/OCS files in that folder, and then make and run the temporary CMD files from there too, and also if desired, it allows you to have the original SKP file located there too...
Can MAC users also please try running a project based on a 'mapped-drive' and report back on issues [if any]...
Feedback please...
It addresses an issue raised by 'Area D'.
It's been updated to allow a project-folder to be located somewhere other than on the the base Windows drive [which is usually 'C:'] - i.e. it's somewhere else, on 'mapped-drive' e.g. 'X:' - and to make the OBJ/MTL/OCS files in that folder, and then make and run the temporary CMD files from there too, and also if desired, it allows you to have the original SKP file located there too...
Can MAC users also please try running a project based on a 'mapped-drive' and report back on issues [if any]...
Feedback please...
