OTOY Forums

Hey guys i rendered a Batmobile Model from Blendswap.com but i can't figure out how to create
bright red lights. When i increase the power it's bright but also loses the colour and gets nearly white.
Any suggestions for making it right?

One solution is to change the camera response curve to linear.
That gives you more scope.
And then, play around...

face

And how can i change this curve?

Under the "Preview Imager" from standard "Agfacolor HDC 100 plus CD" to "Linear/Off"?
You must also play with the other 4 parameters above to become the same brightness.

face