Page 1 of 1
Octane Open Subdiv UV
Posted: Fri Mar 23, 2018 3:17 pm
by mstewart152
is there a way to tell Octane to NOT distort the UV's when using OpenSubdiv? It creates these weird boarder edge seems that are not visible if it were linear. And no, currently I can not use Lightwave Subdiv because of fiber fx error.....
Re: Octane Open Subdiv UV
Posted: Fri Mar 23, 2018 9:32 pm
by LightwaveGuru
mstewart152 wrote:is there a way to tell Octane to NOT distort the UV's when using OpenSubdiv? It creates these weird boarder edge seems that are not visible if it were linear. And no, currently I can not use Lightwave Subdiv because of fiber fx error.....
Capture.PNG
do you have checked the different subdivision Schemes?
snip lwguru
Re: Octane Open Subdiv UV
Posted: Fri Mar 23, 2018 9:50 pm
by mstewart152
yeah, i tried the different subdiv modes, didn't seem to have a noticeable effect. Basically i need a mode that is the same as Lightwaves Linear UV mode. Oh wells.. for this particular model, it won't matter as much, being its going to be covered in fur.