Page 1 of 1
Banding with volumes
Posted: Fri Nov 03, 2017 10:11 am
by Mortimerio
Hi,
I'm using VDB volumes in a scene but there is a lot of banding in some point. Has anyone experienced the same issue?
Thanks
Re: Banding with volumes
Posted: Fri Nov 03, 2017 11:26 am
by paride4331
Hi Mortimerio,
could you give more details or sharing your scene, a wetransfer link using private message if you want.
Regards
Paride
Re: Banding with volumes
Posted: Fri Nov 03, 2017 3:38 pm
by Mortimerio
Thanks, I've send you a private message.
Re: Banding with volumes
Posted: Sat Nov 04, 2017 7:57 pm
by stir
I noticed when i was using Volume in the medium slot of the Daylight system, and the scale of the scene was to high i got banding similar to that, only in circles instead of straight lines.
Might not be the same, but similar atleast.
-Mats
Re: Banding with volumes
Posted: Mon Nov 06, 2017 1:56 pm
by paride4331
Hi Mortimerio,
I tested your scene, there are no particular problems, some errors such as you did with OctaneDaylight medium radius, in fact it was 1, this means your media is applied for a meter radius around the camera, therefore useless.
about horizontal bands, I think they depend on ray epsilon setting. is a very wide scene, try testing it with 0.001 or 0.01.
The .vdb you are using in Km and miles, I think should have medium volumes with different step lenght and volume density,
I used your .vdb in the screenshot, as you can see it is less dense than your scene.
Regards
Paride