OTOY Forums

i'm have many Problem with Material Setting to make emission Object . Because sometime i don't know were is Front of Side . and hard to control direction of Light ..

i think the Split Lighting Tools from matterial setting to Easy Use and sometimes i'm want to make the omni Light now hard to make it .

thanks.

Hi Bagginsnuke,
but Sketchup shows the inverted polygons painted in purple/blue, and reversing them is only one command.
To make an omni light, just create a little cube with emitter material and make it a group or a component.
Octane cannot render emission from backside, so this cannot be changed anytime soon in any plugin.
ciao beppe

bepeg4d wrote:Hi Bagginsnuke,
but Sketchup shows the inverted polygons painted in purple/blue, and reversing them is only one command.
To make an omni light, just create a little cube with emitter material and make it a group or a component.
Octane cannot render emission from backside, so this cannot be changed anytime soon in any plugin.
ciao beppe

thanks. For your Advice .
on setting and Render Now this So good.
but if close project and back to Render agian sometime Material Eror ... i;m so sad T T