OTOY Forums

Hello,

I am demoing Octane for Blender and just trying the different things out.

I read that it was now possible to use smoke with Blender for Octane. While I can get the Volumen Medium to work I can nok get it to work with the smoke simulations. I used the same methods you would normally use with Cycles, but with Octane nodes instead.

I could not find any documentation about this. Is it possible?

/OutOfTime007

Hi OutOfTime007,
Take a look at this short video tutorial I've made about new features, including smoke simulation, of OctaneRender for Blender v.3. The video had been made before fire simulation support was added, so that part is not shown and explaned there.



And new Hair system features are shown here:

Thank You, that was very helpful.

Nice work! +1