Page 1 of 1
What I`m doing wrong?
Posted: Thu Mar 17, 2011 3:45 pm
by foxid
Hi, guys.
Start remembering Octane, but I`m confused why is it so slow and noisy? Can`t work with halo in interior at all!
What am I doing wrong?
Re: What I`m doing wrong?
Posted: Thu Mar 17, 2011 3:53 pm
by matej
Pathtracing is inefficient at lighting indoor areas with very small light sources. You'll have to wait a long time before the noise clean up (if at all) or change your lighting technique (bigger lights / half opened interior / directlighting..)
Re: What I`m doing wrong?
Posted: Thu Mar 17, 2011 4:10 pm
by foxid
Direct is unreal. I need not bigger light, i need halos with D=8cm... Half-room is phisically incorrect..... Bad news. Can`t use octane in commercial yet... Wait for final version.
Thanx for reply, friend.
Re: What I`m doing wrong?
Posted: Thu Mar 17, 2011 11:51 pm
by radiance
Just because it does not render clean in 4 minutes does'nt mean it's unusable,
for complex scenes like this i would wait 60 minutes for a good result.
Also, if you decrease maxdepth to 5 or so it will converge quicker.
Radiance
Re: What I`m doing wrong?
Posted: Fri Mar 18, 2011 8:36 am
by foxid
The situation doesn`t change for 60 min. Picture lighter but too noisy. I will try to lower the depth.
Any changes with noise and render time in final ver 1.00, Radience?