OTOY Forums

Hello,

i use octane 3.4.3 and now i have a new graphic card. On my 980 ti comes an gtx 780 ti.
i have installed the newest nvidia driver. The two cards are not in SLI mode. I had read that it was not necessary, right?
In the octane preview, the cards works. but when i render final, after some pictures the programm give me a error message "not enough memory".
That cant be true, because the scene is not so huge. with one single card, it render good. With both cards, it runs only 5minutes.
The render manager, render 3 from 9 pictures and then crashed. In the previewer, i can read about 3GB ram. That is wrong, because the 980ti has 6GB and 3GB for the 780ti.
It must be 9GB. Whats the problem here ? any idea ?

sreinger wrote:Hello,

i use octane 3.4.3 and now i have a new graphic card. On my 980 ti comes an gtx 780 ti.
i have installed the newest nvidia driver. The two cards are not in SLI mode. I had read that it was not necessary, right?
In the octane preview, the cards works. but when i render final, after some pictures the programm give me a error message "not enough memory".
That cant be true, because the scene is not so huge. with one single card, it render good. With both cards, it runs only 5minutes.
The render manager, render 3 from 9 pictures and then crashed. In the previewer, i can read about 3GB ram. That is wrong, because the 980ti has 6GB and 3GB for the 780ti.
It must be 9GB. Whats the problem here ? any idea ?

Hi,
Can you post your crash screen? Be sure what's crash means. Also read this pls: https://docs.otoy.com/#cinema-4d-v3-per ... renderings

this for VRAM question: viewtopic.php?f=30&t=57642

And these videos(ex. Getting Started video)
https://docs.otoy.com/#28Cinema4D_Plugin_Edition