Page 1 of 1
Unable to enter password to activate slave daemon
Posted: Wed Aug 17, 2016 10:26 am
by HHbomb
Hi, I want to run slave daemon on my third computer, I enter my username, but I can't enter my password , nothing I type is taken in account.
Please help
octane 3.03.3 - win7
Re: Unable to enter password to activate slave daemon
Posted: Wed Aug 17, 2016 10:24 pm
by azen
Hi,
Thanks for bringing this to our attention. If this can be duplicated on our end, this will be amended ASAP.
Just to clarify - is the interface not allowing you to enter your password, or is your valid password not being denied?
Re: Unable to enter password to activate slave daemon
Posted: Thu Aug 18, 2016 6:48 am
by HHbomb
hi, thanks for answer.
The interface is waiting for the password ( an underscore is flashing ) but I can't enter a single letter.
Re: Unable to enter password to activate slave daemon
Posted: Thu Aug 18, 2016 1:02 pm
by HHbomb
Hi again,
It is perhaps my fault as on this computer I forgot to open Octane standalone at first, before trying slave daemond....
so I closed deamond (which can't make authentification) and opend standalone where I have been able to enter my codes.
Thanks.