OTOY Forums

So I have played with this setting before, but only when it starts to show the triangles, then I turn it up. Works great. But one thing I noticed. When the setting is the lowest, it gives different reflections than when its all the way up. Just wondering why that is?

Like I was doing reflections off a sweep and when it was all the way down the reflections were correct. But when it was all the way up, they weren't even close. Should this be happening?

Here is what I mean

https://www.dropbox.com/s/hwueyzoay3c1s ... s.jpg?dl=0

I think this question is better posted in the Octane Standalone 3.01.1 thread, or the general discussion thread. The sum total of my Ray Epsilon knowledge is at https://docs.otoy.com/#60Adjusting%20Rayepsilon.

Paul

Roger that, I will give it a go.